![]() You must also set the VPU core clock to a fixed frequency using force_turbo=1 or core_freq=250 where ![]() This may reduce the maximum usable baud rate for bluetooth and The system service that initialises the modem may also need to be disabled (so it does not connect to the UART).Īlternatively if you still want bluetooth but you also need the primary port to use UART0 (for baud rate or power consumption reasons)Īssert dtoverlay=miniuart-bt (to switch Bluetooth to use UART1 and make UART0 the primary UART) but selects UART1 as the secondary port (disabled by default).selects UART0 as the primary port (enabled by default) and.assert dtoverlay=disable-bt (in /boot/config.txt) which.causes the Pi to draw a lot more current.īottom line: it is not possible to (A) operate the VPU at a variable speed and (B) have bluetooth enabled and (C) use the (full feature) UART0 as the primary port at the same time.it's locked to the highest VPU frequency instead but this.force_turbo=1 is also set (in /boot/config.txt) in which case.this slows the operation of the VPU unless.is required to enable UART1 (Mini UART) to work properly but. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |